iboot gif imageBoot Kits

Boot kits are available for Mercotac® Models 1250, 130, 230, 235, 215-2K, 330, 331, 335, 430, 435, 630, and 830. These kits provide protection against light oil, dust, and water.

2023 Mercotac Cutaway 1250 image The boot kit consists of a flexible vinyl or silicone right angle boot and an attaching plastic bushing. It effectively shields the wire terminals from spray water, oil mist, and dust.

Please note that the boot kit is not watertight, nor intended for waterproofing.

Due to the close fit of the bushing, the boot kit achieves a protection rating of IP51. It is designed to be used on the stationary end of the Mercotac connector. The small tip of the vinyl boot can be trimmed to accommodate different wire sizes.

For models 335, 435, 630, and 830, appropriate disconnect terminals are included with the boot kits to replace the right angle terminals that come with the Mercotac connector.

430 Boot Kit Dims image 430 Boot Kit Dims image

Guidance for using Mercotac® Brushless Slip Rings in engineering designs.

Learning Center Construction & Materials

Learn about our Mercotac® Construction & Materials: Body Materials, Bearing Types, Conductors/Terminals, Thread Sizes, Mounting Options.
Learn More

Learning Center Electrical Characteristics

Learn about Mercotac® Electrical Characteristics: Voltage Rating, Current Rating, Contact Resistance, Circuit Separation, Operating Temperature, Frequency.
Learn More

Learning Center Rotational Characteristics

Learn about Mercotac® Rotational Characteristics: Rotational Speed, Rotational Torque.
Learn More